Medium frequency spot welders require a reliable supply of both air and water for their operation. In this article, we will discuss the steps for installing these sources.
First, the air source must be installed. The air compressor should be located in a dry, well-ventilated area, and should be connected to the air dryer and the air receiver tank. The air dryer removes moisture from the compressed air to prevent rust and other damage to the equipment. The air receiver tank stores the compressed air and helps to regulate its pressure.
Next, the water source must be installed. The water supply line should be connected to the water filter and the water softener, if necessary. The water filter removes impurities and sediment from the water, while the water softener removes minerals that can cause scaling and damage to the equipment.
After the air and water sources are installed, the hoses and fittings should be connected to the spot welder. The air hose should be connected to the air inlet on the machine, while the water hoses should be connected to the inlet and outlet ports on the water-cooled welding gun.
Before turning on the spot welder, the air and water systems should be checked for leaks and proper operation. Any leaks should be repaired before using the machine.
In conclusion, the installation of air and water sources for a medium frequency spot welder is an important step in ensuring the reliable operation of the machine. By following these steps, you can ensure that your spot welder is properly installed and ready for use.
Post time: May-12-2023